1 2 3 4 5 6 7 8 9 10   11 12 13 R D N - - - N - - -

1. RTD Element Type

Formatted as: Material / Resistance (ohms) / Temp. Coefficient (ohm/ohm/°C) Platinum / 100 @ 0°C / .00385 Platinum / 100 @ 0°C / .00392 Platinum / 500 @ 0°C / .00385 Platinum / 1000 @ 0°C / .00385 Nickel / 120 @ 0°C / .00672 Copper / 10 @ 25°C / .00427 NiFe / 604 @ 0°C / .00519 Select one option for your RTD element type.

2. Tip Style / Element Accuracy

Tip Style: Flat Tip Round Tip Vented Tip   Type: .01% .02% .03% .05% .10% .50% 1.00%

3. Configuration

Select One: 2 Wire - Single Element 3 Wire - Single Element 4 Wire - Single Element 4 Wire - Dual Element 6 Wire - Dual Element Other

4. Sheath Operating Temperature

Select One: -325 F to 500 F -325 F to 750 F -325 F to 1200 F Other The maximum temperature of the application affects the calibration, size (diameter) and material of the sensor we select.

5. Sheath Material

Select One: 304SS 310SS 316SS INCONEL Other The application dictates the choice of sheath materials.  304SS and 316SS are most commonly used but temperatures and corrosive conditions can necessitate the use of other materials.

6. Sheath Diameter

Select One: .125" .188" .250" .313" .375" Other The Mineral Insulated thermocouples come in a number of sizes but the choice is greatly influenced by the maximum temperature of the application.  For high temp applications bigger is better.

7. Sheath Length "L"

Enter Inches: Although the accuracy of the thermocouple is not affected by the length of the sheath consult the factory when the probe length exceeds 120 inches.

8. Terminations

Select One: Std Male Plug Std Female Jack Mini Male Plug Mini Female Jack The type of termination selected may be restricted by the wire gauge.

9. Fittings

Select Type: None Fixed Bayonet Fitting SS Fixed Bushing Steel Fixed Hex Nipple SS Fixed Hex Nipple SS Spring Loaded Fixed Hex Nipple Brass Compression (one time adj.) SS Compression (one time adj.) SS Compression (re-adjustable) Other Fittings of all thread sizes, materials and design are available for most applications.   (For Compression Fittings and Fixed Bushing only) Select NPT: None 1/8" NPT 1/4" NPT 1/2" NPT 3/4" NPT (Fixed Bushing Only)

10. Fitting Location "F"

Enter inches from tip ( "N" for None ) Measured from the first thread to the tip of the sheath.  Allow for the thread-in insertion length of the fitting when determining location.

11. Special Options

N None M MgO Construction F Field Bendable T Teflon Coated Probe H High Vibration W Weld Pad I SS ID Tag Y Certificate of Conformance L Mating Connector Z Other

12. Bend Angle

Select One: None 45 Degree Bend 90 Degree bend Other Mineral insulated thermocouples should not be bent on a radius smaller than twice the outside sheath diameter.

13. Bend Location "C"

Enter inches from tip ( "N" for None ) There are minimum bend locations for all Mineral Insulated sensors – dependent on sheath diameter.

1 2 3 4 5 6 7 8 9 10   11 12 13 R D N - - - N - - -